Product description
TESmart 8x1 HDMI Switch 4K@60hz 4:4:4 with RS232 & LAN Ports
Support resolution up to 3840*2160@60Hz, HDCP2.2 compliant
With EDID emulators in each input port, keep PCs always having correct display information
Support hot plug, connect or disconnect devices to the HDMI switch in any time and without turn off devices
Support auto-switching to monitor computers in a specified time interval
Support front panel buttons, IR signals, RS232 serial commands or IP commands to control HDMI switch
Auto input detect and switch
Supports DVI-D single link sources and displays with the use of HDMI-to-DVI adapters
Support multiple switching?
Manual switch:
1. Panel button switch
2. Remote control switch
3. RS232/LAN control switch
Non-manual switch:
4. Automatic Detection (Support automatic input source detection when attaching new input device to the switcher, the switcher will switch to this just plugged in source automatically.)
5. Auto-Scanning Time Interval Setting (Set the switching interval time and automatically switch the input source signal in turn.)
RS232/LAN controller
Connect the RS232/LAN port to any control appointment, then it is able to select the input sources by sending RS232/LAN commands.
You can download the commands on our Website: te-smart.com.
IR extension
Connect the IR extension cable to the IR connection and place the infrared receiver in a clearly visible position that can be easily controlled by remote control.
Standard 1U 19-inch Rack Mount
It is perfect for standard 1U height and 19-inch Cabinet/Rack Design if you maybe use Cabinet/Rack.
With 2 Pcs Rack Ears and some screws.
Support for HDCP 2.2
HDCP stands for high bandwidth digital content protection, a copy protection procedure that excludes the possibility of capturing digital data in the middle of the data stream between the source and the display.
It can be used for products that are compatible with the HDCP scheme, such as DVD players, satellite and cable HDTV set top boxes, etc.
Settings for auto switching time intervals
[MIN]: Press [MIN] to scan a loop between 0~59 minutes.
[SEC]: Press [SEC] to turn a loop between 0~59 seconds.
[Set]: After setting the minutes and seconds, press the [Set] button to enter the setting of the final scan time interval.
[Scan]: Press this button to star or stop automatically scan between input 1 toinput 8, the interval time can be set by button [Set], [MIN], [SEC]as described above.
Package
1 *8x1 HDMI switch
1 *DC 12V 2A Power supply
1 *IR remote control
1 *IR receiver cable
1 *3-pin connection (for RS232)
2 *Rack ears
1 *Quick Start Guide